527F rigid tapping setup instructions

The 527F requires the rigid tapping software to be installed, see OPTIONS command to display status.

Next the machine must support rigid tapping see this post to help determine if machine supports rigid tapping:

www.calmotion.com

Add Rigid Tapping capabilities to the CNC control | Calmotion

First the machine will need to have a spindle encoder on the spindle motor and the spindle drive will need to be a vector drive. There are a couple of ways to find out: • Make a physical inspection at the motor. First remove any cover or filters on top of the spindle motor. The encoder will be inst

Basically the setup is 99% the same as the Fadal, the RAMP and GAIN numbers will be typically be a bit different compared to what the CNC88 would end with. Use the instructions attached. You auto tune the drive. Using the Fadal service tool thread you adjust the GAIN and RAMP for the Rigid tapping in SETP:

Required FADAL SVT0077 Rigid tapping gauge

Rigid tapping calibration, See attached procedure, and video:

https://drive.google.com/open?id=1Frf5tQnAhnlMEB09GebM3MFLhziJb4R9

"Gain is too" low video:

https://drive.google.com/file/d/1uVEnTssDEUBuGOeUoRTG8jDcsoKIag6-/view?usp=drive_link

"Gain is just right" video:

https://drive.google.com/file/d/1WpJMKpPai9EpYQgWmX3RvITrRkIX9F04/view?usp=drive_link