The Mitsubishi E04 ' DEVICE NOT READY ' error message typically indicates the CNC parameters do not match the Calmotion parameters. Match the baud rate, flow control and RS232 port settings on Calmotion to the Mitsubishi.
• Check communication parameters (see Mitsubishi users manual)
• Cable incorrectly configured or not connected. Make sure that the included Calmotion cables and connectors are being used.
Fanuc P/S Alarm 02 ' TV PARITY ALARM '
• The number of characters in a block is odd. This Fanuc alarm will be generated only when the TV
check is in effect. Disable all parity checking on the Fanuc.
• Make sure the Fanuc ' TV Check ' parameter setting is set to ' 0 ' or disabled
• Make sure the Fanuc control is set for ' ISO ' mode and not ' EIA ' mode
Fanuc P/S Alarm 87 ' BUFFER OVERFLOW '
• Flow Control or Data/Parity/Stop parameters are not configured properly
Compare the Fanuc settings and the Calmotion settings. The flow control settings need to be the same as well as the RS232 port settings.
Typical Fanuc setting for flow control would be XON/XOFF or DC codes. The Calmotion will need to be set to SW XON/XOFF
Typical Fanuc RS232 port settings are 7 data bits, Even parity and 2 stop bits. Set the Calmotion to the same.
543 Designated data is not right
Try previously working program to help diagnosis
Program data might be missing the program number O#
G-code not right, look at contents of file
