5C
Rotary (Fanuc and Fadal
versions)
The 5C series of rotary tables
from Calmotion come pre-wired
for either Fadal or Fanuc CNC's.
Complete wiring harnesses in
addition to servo packages are
also available for both styles
of controls in order to
facilitate installation.
The 5C gear sets are made of heat treated steel using throated helix gears. The increased contact area of this design reduce wear to extend the life of the rotary table without sacrificing accuracy. The increased contact area also absorbs higher shock loads. In addition, the dual adjustment capability of the Calmotion 5C provides better gear mesh when compared to rotary tables limited to only a single adjustment.
The 5C comes with standard with a manual collet closer. The manual collet closer has a mechanical force multiplier for both opening and closing of the collet. An optional air collet closer features an impressive 3,000 lbs of thrust @ 100 PSI. Holding force is maintained with variations or even complete loss of air pressure.
Motor and encoder wires are epoxy sealed on the motor end to protect against contamination. (A common point of failure for many rotary tables.)
